Other than a battery backup in case of power failure and a high water alarm in case of pump/switch failure, is there any way to make these systems safer? Thanks. This thing seems like an accident waiting to happen. I have had to go into the sewer ejection system more times than I can count to adjust, fix, replace one thing or another and the system is only 11 years old. While doing this job I examined the check valve because things didn't sound right (what does it mean when you know there might be a problem with your sewer ejection system because it doesn't "sound" right?) and discovered that the flap had been torn off and was just bouncing around within the valve. Once I removed the crud it seemed to work okay, although I will have to do more testing. The Sanicubic 1 can be retrofitted into an existing sewage ejector basin of at least 24-in in diameter for a quick and easy pump exchange Note that the effluent pipe leading into the pump has to be installed with the required 0. There was "crud" on the float and, while the float did rise with the water level, it would not trigger the pump. Shop water pumps and a variety of plumbing products online at. The reason for my question is because I have had to remove the sealed cover, and go back in to correct an issue with the float not triggering the pump.again. A sewage pump, which works alongside the septic system, helps ensure the process is smooth and seamless. I am now worried that the flap is unable to take the force of the water being discharged. Every day, whether you are aware of it or not, you rely on your septic system to efficiently flush and drain away your household’s waste. A sewage ejector pump collects and sends liquids and solids up to the level of the sewer line. The one that recently failed was from Lowes and cost about $60? It was installed vertically on the ejection pipe by the original plumber. Are these things prone to failing, or can I purchase a better one. The circular flap was torn off from the rubber "hinge" on the inside of the check valve. Recently the pump would not start because the float ball for the pump was caked with scum and it would not rise to the correct "angle" to trigger the pump.Īlso the check valve has failed and it was less than 2 years old. The sewage pit gets gummed up with, what I am assuming, is soap scum from the laundry and shower. The bathroom is not used for solid waste (no #2), but is used for liquid waste (yes #1). Is there a way to prevent the build-up of soap scum for a sewage ejector pit? Currently the sewage ejector system services the laundry room and a bathroom located in the basement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |